EN RU CN
Micro Brushless Re-wind for Button Cameras
  • Hello friends,

    I have a question about the feasibility of winding a micro brushless motor with a resistance in the 5-20 ohm range (or whatever will work with the controller board - arduino or other) and with minimal cogging. Would this be achievable with a very high gauge wire that could be hand wound without complex machinery? Or am I looking at this wrong - could I adapt an arduino to very low resistance motors?

    I am specifically looking at motors like the AP-02 and 03. Generally those under 5 grams.

    Any thoughts are much appreciated! Thanks!