Well i mounted my gimbal into an UAV and two weeks ago we had a crash with all the frame.....until then all was working fine, but after that we can't calibrate the gyroscope as we hold the camera on a lock (stable) position and it seems like the new calibration position is not been saved, it returns to the original position we calibrated the camera before the crash.

We tried reloading the firmware and performing like a thousand times all the calibration process again but we are not able to get a solution.

We were thinking if this is a profile issue we notice that there is available like 3 profiles, but we are not sure how to select it for the gimbal at the GUI. Another possible problem is a memory problem like the crash might have damages something from the controller.