EN CN
Cannot use Servo tester to control pitch angle
  • NYANA_Myanmar
    I got 2 x 3 axis alexmos gimbals. from the old one I can use to adjust pitch angle with servo tester. or yaw.
    On the old one I use FW 2.4_B7 , When I plug RX_Pitch and RX_Roll(and choose at RC setting tab/RC input mapping/PITCH/RC_PITCH_PWM), the servo tester have voltage and can use.
    Now I setup new 3 axis gimbal with same Alexmos 3 axis board and use same firmware. It's all fine with movement/follow mode, But on this new one, I cannot get any voltage on RX_PITCH or RX_ROLL or cannot use. I have no radio to test, even we use radio how to get +5V for RX module. So anyone have idea how to solve? I buy different store, old one buy from ebay, new one from Hobby King.
  • NYANA_Myanmar
    Oh I am bad, I could not read all forum, now I found it myself that someone suggest, solder L1 which is locate near sensor pins on the board, so that have power 5+V. Now very perfect.
Add a Comment